Wacker Neuson BFS 1350AL Operator's Manual - page 12
T00833GB
10
DESCRIPTION
General instruction for the use of diamond blades
*
Never use a blade of a diameter larger than necessary to cut a certain depth.
*
In case the blade stops operating, take it out of the cut before starting the engine anew. Check the belt ten-
sion if the cutting disc should get stuck in the cut. Check the flanged nut and make sure that it is correctly
tightened.
*
Always cut in a straight line. Mark the line clearly allowing the operator to follow it easily without having to
guide it from one side to the other to come back to the line (Do not cut narrow curves).
*
Sufficient drive power is essential, therefore always cut with engine at full throttle.
*
Caution: Special care is required when working on slopes (lanes and surfaces). Make sure the machine is
not exerting a lateral pressure on the blade.
*
Never exceed maximum speed indicated on the blade!
*
Only use the appropriate cutting blade for the material you are going to cut (asphalt, concrete, ...). Wacker
has an extensive selection of diamond blades in different grades of qualities for you.
*
Do not cut crushed stone or similar materials when using a diamond blade. Uneven wear may occur when
cutting road edges or two different materials. Special care is required if the material to be cut contains in-
clusions such as reinforcements, etc. as this would easily overload the blade. Proceed carefully when sta-
ring to cut, lower the blade slowly.