Wacker Neuson BH24 Operator's Manual - Description
Description
T01112GB.fm
18
4.
Description
4.1
Applications
When breaking up concrete and asphalt or soil that is full of boulders,
for breaking off in concrete, brickwork and other building materials
(overgrown or frozen ground) etc., for tearing up streets and concrete,
asphalt, tar, wood and pavement, for paring clay, loam, peat and salts,
for crushing soil that has been pressed by vehicles, for ramming in
posts and grounding rods with the respective tools. In track laying to
pack ballast under railway sleepers.
4.2
Transport to worksite
Requirements:
∗
When transporting the Wacker machine, use only suitable hoisting
gear with a minimum load-bearing capacity of 30 kg.
∗
Always turn off the motor during transportation!
∗
When transporting on the cargo area of a vehicle, fasten the Wacker
machine.
Note: Also observe the regulations in the chapter Safety information!
4.3
Functional description
The drive motor drives the percussion system via gears and
connecting system. The torque is transferred non-positively by the
centrifugal clutch.
The drive motor works according to the two-cycle principle and is
started mechanically via a recoil starter.
Machines with remote cut-off:
The machine is equipped for the connection of a remote cut-off. For
further information on the remote cut-off, refer to the manufacturer's
operator's manual.
To operate machines without remote cut-off, the shorting plug must be
plugged into the connector.