Wacker Neuson BH24 Operator's Manual - Maintenance
Maintenance
T01113GB.fm
22
6.2
Engine
6.2.1
Air filter: Clean by knocking or blowing (from inside to the outside), do
not use gasoline or similar cleaning agent! Replace filters that are very
dirty or that have been used often. Check the filter holder before
inserting.
6.2.2
Fuel supply and carburetor: Clean the components regularly. Blow
through the jets.
6.2.3
Spark plug: Clean sooted or wet spark plugs. Check the spark plug air
gap (0.5 mm).
6.2.4
Ignition: Gap between the fan wheel and ignition armature
0.3 - 0.4 mm.
6.2.5
Cylinder: Keep the cooling ribs clean.
6.2.6
Starter: Lightly lubricate the bolts after approx. 200 hours in operation.
6.3
Percussion system, crankcase
Lubricante (see technicla data)
Lubrication check
6.3.1
After 20 hours of operation, the hammer must be lubricated via the
lubrication nipple provided with a red mark which is positioned on the
crankcase.