Wacker Neuson DPU 4545 Operator's Manual - page 26
8 Operation and use
26
100_0202_op_0009.fm
8.3.3
Commissioning the machine (electric start)
1. Put the throttle lever in the full throttle position.
2. Insert the ignition switch key into the ignition lock and turn to the right. The charge control lamp will
illuminate and the acoustic signal will sound.
3. Turn ignition switch key to position ll. As soon as the engine starts, release the ignition switch key.
4. Put the throttle lever in the idling position.
5. Allow the machine to warm up by idling for a few minutes.
Item
Designation
Item
Designation
1
Throttle lever
3
Ignition lock
2
Decompression lever
4
Charge control lamp
NOTICE
In extreme cold, actuate the decompression lever as well and push it up. In this position,
the decompression automation system audibly locks into place and the engine is ready to
start.
NOTICE
As soon as the engine starts, the vibration will begin.