Wacker Neuson DPU 4545 Operator's Manual - page 27
8 Operation and use
100_0202_op_0009.fm
27
Machine with Compatec – compaction display (optional)
1. During the first few seconds after starting the machine, a light progress bar appears on the display
unit.
2. LEDs light up starting from left to right.
3. All LEDs will briefly light up again at reduced brightness.
4. The sensor is thus successfully tested and the display is ready for operation.
8.4
Operation
In accordance with the intended purpose, the operator should stand behind the machine.
Guide and steer machine using the control handle.
8.4.1
Select the travel direction
1. Put the throttle lever in the full throttle position.
2. Select travel direction and speed with the control handle.
Item
Designation
Item
Designation
1
Display unit
2
LEDs/light progress bar
NOTICE
If all LEDs light up, the system is fault-free. The LEDs will then switch off one after the
other.
NOTICE
If all LEDs permanently light after initialization, the sensor has not been successfully
tested; see troubleshooting chapter.
Item
Designation
Item
Designation
1
Forward
2
Reverse
1
2
1
2