GB
8
Small-scale spray attachment
Interruption of Work
i
When processing 2-component varnishes, clean the device immediately.
Shutting down and cleaning
Please also refer to the instructions of the basic device.
Switch the unit off. Vent the container in case of longer breaks and after the work has
1)
been terminated. This can be done by briefly turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
Screw of the container and empty it. Pull out the suction tube with container seal.
2)
Preclean the container and feed tube with a brush. Clean the ventilating bore
3)
(Fig. 1, C).
CAUTION!
Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw off the valve
4)
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
5)
seal and nozzle with a brush and solvent or water.
Spare Parts List (Fig. 1)
Pos. Designation
Order No.
3
Nozzle seal
0414 353
4
Nozzle
0417 370
5
Union nut
0417 319
6
Air cap XL
Australia (AUS) version order no. in brackets
0417 371
AUS (0417 376)
9
Container seal
0417 358
10 Feed tube
0417 378
11 Container 250 ml with cover
0417 922
12
13
14
Ventilating hose
Valve cover
Diaphragm
2304 027
15 O-Ring
0417 308
16 Viscosity test cup
0413 306
The new CLICK&PAINT SYSTEM with additional spray attachments and accessories
offers the richt tool for each work.