Waldorf GT8600G Installation And Operation Manual - page 10

8 

Installation

NOTE:  The operating pressure to be measured at 

the manifold test point and with both 

burners operating at the “High Flame”  

setting. 

8. 

Turn off the mains gas supply and bleed the gas 

out of the appliance gas lines. 

9. 

Turn on the gas supply and the appliance. 

10.  Verify the operating pressure remains correct. 

Commissioning 

1. 

Before leaving the new installation; 

a.  Check the following functions in accordance with the operating instructions specified in the 

“Operation” section of this manual. 

•  Light the Pilot Burner. 

•  Light the Main Burners. 

•  Check the Low Fire burner operation. 

•  Check the High Fire burner operation. 

b.  Ensure that the operator has been instructed in the areas of correct lighting, operation, and 

shutdown procedure for the appliance. 

2. 

This manual must be kept by the owner for future reference, and a record of 

Date of Purchase,

Date of Installation 

and 

Serial Number of Appliance 

recorded and kept with this manual. 

(These details can be found on the Rating Plate attached to the R/H side panel (refer to 

the “Gas Connection” section). 

NOTE:  If for some reason it is not possible to get the appliance to operate correctly, shut off the 

gas supply and contact the supplier of this appliance. 

Pressure Test Point 

Low Fire Adjustment 

Fig 3