Waldorf GT8600G Installation And Operation Manual - page 12
10
Operation
Lighting the Pilot Burners
1.
Depress the gas control knob and rotate anti-clockwise to the ‘PILOT’ position.
2.
With the control knob depressed, press the piezo ignition button on the front control panel
adjacent to the gas control knob until the pilot burner ignites. Pilot ignition can be viewed through
openings in the control panel.
3.
Hold in the gas control knob for approximately 10 seconds, then release. The pilot burner should
remain alight. If not repeat Items 1 to 3.
4.
Repeat Items 1 to 3 to light the second pilot burner.
5.
‘FULL’ flame can now be achieved by rotating the gas control knob anti-clockwise to the first stop.
6.
‘LOW’ flame can be achieved by depressing and rotating the gas control knob fully anti-clockwise.
Using the Griddle
1.
Light the pilot burners as shown above.
2.
Turn the gas controls to the ‘FULL’ flame position and allow the griddle plate to preheat for 10
minutes if starting from a cold start.
3.
Place the product to be cooked onto the griddle plate.
4.
For intermediate heat, position the gas control knob between the ‘HIGH’ and ‘LOW’ positions to
achieve the desired heat.
5.
During idle periods, the burners can be turned down to maintain an appropriate griddle plate
temperature or the gas controls can be set to the ‘PILOT’ position as required.
Using the Toaster
1.
Light the pilot burners as shown above.
2.
If starting from cold, set the burners to the ‘FULL’ flame position and allow 5 minutes preheat before
commencing toasting.
3.
Adjust the rack position to the desired height.
4.
Place the product on the rack to toast.
5.
Best toasting results are achieved using the shaded area of the toast rack as per the diagram
below.
6.
With the main burners alight, the individually controlled burners can be operated to suit food
quantity requirements.
7.
Each burner is operated by an ‘OFF’ / ‘PILOT’ / ‘HIGH’ / ‘LOW’ gas control. The ‘HIGH’ position is
recommended for most grilling, cheese melting functions and the ‘LOW’ position for a reduced heat
setting.
OPTIMUM
TOASTING
AREA
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, the appliance requires
IMMEDIATE service by a qualified service person and should not be used until such service is
carried out.
IMPORTANT