Waldorf GT8600G Installation And Operation Manual - page 19
17
Gas Conversion and Specifications
Gas Specifications
- Australia / New Zealand Only:
- UK Only
NOTE:
*
The burner operating pressure is to be measured at the manifold test point with both
burners operating at full setting. The operating pressure is ex-factory set, through
the appliance regulator and is not to be adjusted, apart from when converting
between gases, if required. (Refer to the ‘Gas Conversion’ section for details).
Natural Gas
LP GAS (Propane)
Main Burner Injector
2.10 mm
1.30 mm
Pilot Burner Injector
0.35 mm
0.23 mm
Low Fire Adjustment
1 turn out (c.c.w.)
½ turn out (c.c.w.)
Operating Pressure
1.0 kPa (*)
2.5 kPa (*)
Burner Aeration Gap
15 mm (Open)
15 mm (Open)
Gas Regulator Cap Screw
Supply Pressure
1.13 - 3.40
kPa
(4.5” - 13.5” w.c.)
2.75 - 4.50 kPa
(11” - 18” w.c.)
Natural Gas (G20)
Propane (G31)
Main Burner Injectors
2.10 mm
1.30 mm
Pilot Burner Injectors
0.35 mm
0.23 mm
Low Fire Adjustment
1½ turn out (c.c.w.)
½ turn out (c.c.w.)
Operating Pressure
10 mbar (*)
26 mbar (*)
Burner Aeration Gap
15 mm (Open)
15 mm (Open)
Gas Regulator Cap Screw
Supply Pressure
20 mbar
37 mbar