Waldorf KB 37 User Manual - page 11
7
CV/GATE INTERFACE
7.4
Reset
7.4
Reset
The Reset output delivers a short +5V trigger pulse each time a MIDI Stop event
is received.
7.5
Velocity
The Vel output delivers a signal in the range 0..+5V according to note velocity
1..127 (note velocity 0 means Note Off and is therefore not available).
7.6
Aftertouch
The AT output delivers a signal in the range 0..+5V that corresponds to the
keyboard pressure (channel pressure) 0..127.
7.7
Ctrl-X / Pitch 2
This output delivers a signal in the range 0..+5V that corresponds to a user-
definable MIDI control change message. The button on the left side next to the
jack is used to learn the control change number.
Every time a valid MIDI CC message is received for this output, the LED inside
the learn button will flash.
This is how you set the control change number for this output:
• Press and hold the button next to the output
• Send the desired control change message via MIDI.
• Release the button again
Hint: You can also assign the KB37’s modulation wheel to this output which will
then duplicate the signal of the Wheel output.
The default control change number for this output is CC# 2.
Alternatively, Ctrl-X can be used as second pitch CV output for duophonic
setups. In this case, the output delivers a control voltage corresponding to a
second voice that can be patched to a separate oscillator.
This is how you enable/disable the output for Pitch 2:
• Press and hold the Setup button
• Press the Ctrl-X button next to the output
• Release both buttons again
In Pitch 2 mode, the LED inside the Ctrl-X button will blink.
The output signal is dependent on the setting of the Note Priority switch and
tries to provide a useful complement to the signal on the main Pitch output:
Setting
Pitch
Pitch 2
Lowest
Lowest note
Highest note
Last
Last note
Second to last note
Highest
Highest note
Lowest note
Note: The Pitch 2 signal will also respect glide and pitch bend wheel.
Hint: If you prefer to only have one pitch output affected by the wheel, set the
Pitch Bend Range to 0 and patch the Bend output signal seperately.
7.8
Ctrl-Y
This output behaves in the same way as described above for Ctrl-X.
The default control change number for this output is CC# 4.
7.9
Ctrl-Z
This output behaves in the same way as described above for Ctrl-X.
The default control change number for this output is CC# 11.
11