Waldorf KB 37 User Manual - page 8
4.5
Back Panel
5
CONNECTIONS
4.5
Back Panel
The back panel provides the connectivity needed to integrate the KB37 into
your setup.
1
Mains socket with power switch and fuse
2
Extension connector
3
Audio outputs (stereo)
4
Sensor input (level 0..+5V)
5
Sustain pedal input (polarity is detected automatically)
6
MIDI Thru
7
MIDI Out
8
MIDI In
9
USB jack for host connection
5
Connections
5.1
Power
An AC power outlet is needed to power up your KB37. Make sure that the
power switch on the back panel is turned off before you connect your unit. Use
the cable supplied with the unit to make the connection.
The KB37 uses an internal power supply unit that can be switched between
110V and 220V. To avoid any damage, ensure that the right voltage is selected
for your region.
5.2
Audio
Connect the audio outputs on the back panel to a mixing console, audio
interface or similar. The signal at these outputs is taken from the jacks at the
audio panel on the right side of the unit, attenuated by the level pot.
The KB37 features a stereo signal path that is also buffered by an output stage.
Even when you’re using a mono setup within your module patches it’s not a
bad idea to make a two-channel connection to your mixer. As long as you
use the Left / Mono In jack only on the front panel, the signal is sent to both
outputs. This way you can switch between mono and stereo output quickly by
just inserting a patch cable.
8