Waldorf RN8110GE Installation And Operation Manual - page 12
10
Commissioning
1.
Before leaving the new installation;
a. Check the following functions in accordance with the operating instructions specified in the
‘Operation’ section of this manual.
• Light the Target Top Pilot Burner.
• Light the Target Top Main Burner.
• Check the Target Top Low Fire Burner operation.
• Check the Target Top High Fire Burner operation.
• Check the Oven Heating.
• Check the Oven Thermostat operation.
• Check the Oven Fan operation (GEC models only).
• Check the current draw and loading for the equipment. Refer specification section for
correct electrical requirements.
•
C
heck that all the connections are correct and that all cover panels have been re-fitted.
• Ensure that this instruction manual is left with the appliance.
• Ensure that all the relevant details and contacts have been added to the front of this
manual.
b. Ensure that the operator has been instructed in the areas of correct lighting, operation, and
shutdown procedure for the appliance.
2.
This manual must be kept by the owner for future reference, and a record of the
Date of
Purchase,
Date of Installation
and
Serial Number of the Appliance
recorded and kept with
this manual.
(These details can be found on the Rating Plate attached to the front right
hand corner of the bottom sill. Refer to the ‘Gas Connection’ section).
NOTE:
• If for some reason it is not possible to get the appliance to operate correctly, turn off the
electrical power and gas supply and contact the supplier of this appliance.
•
Make sure that the electrical and gas supply are turned off before any service or
maintenance work is carried out on the appliance.
Installation
gpd.sunwayinfo.com.cn
gpd.sunwayinfo.com.cn