Waldorf RN8200G Installation And Operation Manual - page 24
22
NOTE: It is imperative that the trivet supports are correctly
re-fitted to the appliance to ensure that the trivets
locate correctly and sit flush and level. NOTE that
the trivet support front end, side rail profiles are
different at either side and only one of the side rails
seat into the cut-out in the Cooktop. where as the
rear end of the trivet support side rail profiles are
the same and have 2 cut-outs to locate into.
b. Refit the burner bowls onto the manifolds protruding
through the splash guards, taking care not to damage
the thermocouple (and pilot tube for -PF Option)
which is close to the manifold.
NOTE: The burner bowl (cast item) has 2 locating holes drilled into the base flange (See Fig 7),
these are to locate the burner bowl to the cap screw on the gas manifold when re-fitting the
burner bowl onto the gas manifold
(Refer to Fig 8 [F-Option] and Fig 9 [PF-Option]).
c. Refit the burner caps (cast brass) onto the burner bowls already fitted to the manifold. These are
a loose fit into the burner bowls.
d. Refit the trivets to the Cooktop, taking note that the trivets are manufactured with a lip on one
edge, the lip must always be fitted to the outer edge (front and back) of the Cooktop. (See Fig
10).
e. Refit the grease / spill tray(s) to the Cooktop.
Periodic Maintenance
NOTE: All maintenance operations should only be carried out by a qualified service person.
To achieve the best results cleaning must be regular and thorough and all controls and mechanical parts
should be checked and adjusted periodically by a qualified service person. If any small faults occur, have
them attended to promptly. Don't wait until they cause a complete breakdown. It is recommended that
the appliance is serviced every 6 months.
Gas Control Valve Re-Greasing
The gas control valve should be dismantled and greased every 6 months to ensure the correct
operation of the gas control valve.
To carry out this operation;-
a. Remove the gas control knobs from the gas tap spindles by
pulling the knobs away from the control panel.
b. Remove the drip tray from the appliance.
c. Remove the two screws on the underside of the control
panel, securing the control panel to the hob.
d. Remove the control panel from the front of the appliance.
e. Remove the 2 screws holding shaft plate to gas control
body and remove control shaft and plate.
(See Fig 11).
Note orientation of shaft for correct re-assembly.
f. Using needle nose pliers or similar, pull out gas control
spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock
grease or lubricant such as ROCOL - A.S.P (Anti
scuffing paste) / Dry Moly Paste to the outside of
the spindle.
(See Fig 12).
h. Replace spindle and re-assemble the gas control
in reverse order.
i. Refit the control panel to the appliance and
secure with 2 screws.
j. Refit the knobs to the gas control valve spindles.
Cleaning and Maintenance
For the Refrigeration Cabinet Cleaning and Maintenance refer to the Refrigeration Cabinet
Installation and Operation Manual supplied with the appliance.
Fig 10
Notice Lip on
Trivet Edge
Spindle
Two Screws
Fig 11
Fig 12