Waldorf RN8200G Installation And Operation Manual - page 29
27
Griddle
Pilot Burner
a. With the gas supply turned off at the main supply,
remove the griddle plate section by lifting it
straight off the Cooktop.
b. Remove the gas control heat shield from around
the griddle burner, this is just a push in fit.
c. Disconnect the piezo igniter from the mounting
bracket. (For access purposes).
d. Disconnect the pilot supply tube from the pilot
burner with a 13mm (½") A/F spanner.
e. Remove existing pilot injector and replace with the
correct size for the gas being used. Refer to the
‘Gas Specifications’ table at the end of this section,
for correct injector sizes.
f. Re-connect the pilot supply tube to the pilot
burner with a 13mm (½") A/F spanner.
g. Refit the piezo igniter to the mounting bracket.
h. Repeat Items a) to g) for all griddle pilot burners.
Main Burner
a. Remove the main burner from the burner box by
removing the securing screw at the end of the
burner, this will reveal the main burner injector.
b. Remove and replace the main burner injectors
with correct size injectors. Refer to the ‘Gas
Specifications’ table at the end of this section, for
correct injector sizes.
c. Refit the burner to the griddle burner box.
d. Refit the gas control heat shield to the griddle
burner box.
e. Refit the griddle plate section to the top of the
Cooktop.
f. Repeat Items (a. to (e. for all griddle main
burners.
g. Turn ‘ON’ the gas supply at the mains, re-light the
griddle burners and check the flame size on the
‘LOW’ flame position.
Low Fire Adjustment
a. To adjust the griddle burner ‘LOW’ fire adjustment,
remove the griddle gas control knobs from the
front of the control panel.
b. Adjust the low fire adjustment screw on the
griddle gas control valve only, to obtain the
desired flame size.
NOTE: The ‘Low Fire Screw’ should be sealed with
coloured paint on completion of the low fire
adjustment.
Gas Conversion and Specifications
Spring Adjusting
Nut
Fig 26
Piezo Igniter
Thermocouple
Pilot Burner
Gas Control
Heat Shield
Fig 25
Burner
Securing
Screw
Low Fire Adjustment Screw
Fig 27