Waldorf RN8200G Installation And Operation Manual - page 27
25
11. Turn on the gas supply at the mains, re-light the burners and check the flame size on the simmer
(LOW) position.
NOTE: The right hand gas control valve supplies the rear burner and the left hand gas control valve
supplies the front burner.
12. Refit all the trivet supports to the top of the appliance. Note the orientation of the trivet support
when re-fitting as the front end side rail profiles are different from the rear end side rail profiles.
(See Fig 14).
13. Refit the trivets to the top of the appliance taking note that the trivets are manufactured with a lip
on one edge, the lip must always be fitted to the outer edge (front and back) of the Cooktop. (See
Fig 13).
Low Fire Adjustment
a. To adjust the open burner low fire adjustment,
remove the gas control knobs from the front of the
control panel.
b. Adjust the low fire adjustment screw on the open
burner gas control valves to obtain the desired
flame size.
(See Fig 17).
NOTE: The ‘Low Fire Screw’ should be sealed with
coloured paint on completion of the low fire
adjustment.
Open Burners ('PF' - Pilot & Flame Failure Option)
1.
Turn ‘OFF’ the gas supply at the main supply.
2.
Remove the trivets from the top of the appliance, taking note
that the trivets are manufactured with a lip on one edge, the
lip must always be fitted to the outer edge (front and back) of
the Cooktop. (See Fig 13).
3.
Remove the burner caps and burner bowls (these are a loose
fit to the manifold) from the top of the gas manifold, taking
care not to damage the thermocouples and pilot burners fitted
through the manifold splash guard.
4.
Remove all the trivet supports from the top of the appliance.
Note the orientation of the trivet supports when removing.
The trivet support front end side rail profiles are different from
the rear end side rail profiles. (See Fig 14).
5.
Remove the pilot burner shields from over the pilot burners /
thermocouples by removing the 2 screws securing the pilot
burner shields to the splash guards. (See Fig 19).
6.
Remove the splash guards covering the burner manifolds by
unscrewing the two allan headed screws. Carefully remove
the splash guards taking care not to damage the pilot burner
tubes and thermocouples protruding through the splash
guard.
Main Injectors
a. Unscrew and remove the main injectors (½ A/F) from the
gas cocks.
(See Fig 20).
b. Replace with the correct size injectors. Refer to the ‘Gas
Specifications table’ at the end of this section and the
Rating Plate for correct injector sizes for the corresponding
gas.
• For Bench, Cabinet Base and Leg Stand Models,
the Rating Plate is attached to the underside of the right
hand side, front Cooktop lower trim.
Gas Conversion and Specifications
Manifold Test
Point
Low Fire Adjustment Screw
Fig 17
2 Pilot Burner
Shield Screws
Main Injector
Pilot Injector
Plug
Fig 18
Fig 19
Fig 20
Pilot Burner
Shield