Waldorf RN8410G Installation And Operation Manual - page 6
4
Specifications
Gas Supply Requirements
- Non CE Only (Australia / New Zealand):
- CE Only:
Appliance Classification
Category:
II
2H3P
(20, 30 / 37).
Flue Type:
A
1.
*
Measure burner operating pressure at the manifold test point with two burners operating at
full setting. Operating pressure is ex-factory set, through appliance regulator and is not to be
adjusted, apart from when converting between gases, if required. (Refer to ‘Gas Conversion’
section for details).
Gas Connection
Gas supply connection point is located at rear of appliance, approximately 130mm from right hand
side, 32mm from rear and 655mm from floor and is reached from beneath appliance. (Refer to
‘Dimensions’ section).
Connection is ¾" BSP male thread.
Natural Gas (G20)
Propane (G31)
Open Burner
(each)
Griddle
(each 300mm section)
Oven
Open Burner
(each)
Griddle
(each 300mm section)
Oven
Heat Input
(nett)
Nominal
6.5 kW
5.5 kW
6.5 kW
6.5 kW
5.5 kW
6.0 kW
Reduced
1.75 kW
1.85 kW
1.1 kW
1.75 kW
1.95 kW
1.05 kW
Gas Rate
(nett)
Nominal
0.69 m
3
/hr
0.58 m
3
/hr
0.69 m
3
/hr
0.51 kg/hr
0.43 kg/hr
0.47 kg/hr
Reduced
0.19 m
3
/hr
0.20 m
3
/hr
0.12 m
3
/hr
0.14 kg/hr
0.15 kg/hr
0.09 kg/hr
Supply Pressure
20 mbar
30 / 37 mbar
Burner Operating
Pressure
9.5 mbar (*)
26 mbar (*)
Gas Connection
3
/
4
” B.S.P. Male
Natural Gas
LP Gas (Propane)
Input Rate (N.H.G.C.)
- each Open Burner
28 MJ/hr
(26,538 Btu/hr)
28 MJ/hr
(26,538 Btu/hr)
- each 300 mm Griddle Section
21 MJ/hr
(19,900 Btu/hr)
21 MJ/hr
(19,900 Btu/hr)
- Oven
24 MJ/hr
(22,748 Btu/hr)
24 MJ/hr
(22,748 Btu/hr)
Supply Pressure
1.13 - 3.40 kPa
(4.5” - 13.5” w.c.)
2.75 - 4.50 kPa
(11” - 18.0” w.c.)
Burner Operating Pressure
0.95 kPa (*)
(3.7” w.c.)
2.6 kPa (*)
(10” w.c.)
Gas Connection
3
/
4
” B.S.P. Male