Waldorf SN8200G Installation And Operation Manual - page 10

8 

Installation 

Wall Mounting (To Non-Combustible Wall Only) 

1. 

Fix wall mounting bracket to wall with six screws, in a position where the  top of bracket is level and 

at least 945mm (38”) above any surface beneath unit.  This will ensure that bottom of Salamander is 

at least 600mm (24”) above any surface. 

2. 

Fit two black plastic spacers to top rear  

corners of unit.  Leave them unscrewed by 

approximately 5mm. 

3. 

Fit two adjusting screws / bolts into nutserts 

at bottom rear corners of unit.  These 

should protrude approximately 30mm from 

rear of Salamander. 

4. 

Lift Salamander onto wall bracket, lining up 

black plastic spacers on salamander with 

mounting notches in bracket. 

5. 

Lower Salamander onto mounting bracket. 

6. 

Tighten black spacers securely and adjust levelling 

screws / bolts to ensure that unit is level. 

~ 5mm 

~30mm 

Fig 1 

Fig 2 

Fig 3 

Fig 4