Waldorf SN8200G Installation And Operation Manual - page 15

13 

Cleaning and Maintenance 

General 

 To achieve the best results, cleaning must be thorough, and all controls and mechanical parts 

checked and adjusted periodically by a competent serviceman.  If any small faults occur, have them 

attended to promptly. 

 Don't wait until they cause a complete breakdown. 

Racking 

 To clean this unit and racking system and to achieve the best results, it is recommended that racking 

is removed completely from the unit and cleaned independently.  This will allow for a more thorough 

cleaning of the Salamander. 

 To remove racking system, carry out the following instructions. 

1. 

Remove Trough Tray from underside of salamander unit. 

2. 

Remove Branding Plate from rack (if fitted). 

3. 

Slide rack out of side racks and remove from unit. 

4. 

Remove left and right hand side racks from unit by removing single securing screw from each 

of side racks. 

5. 

Withdraw left and right hand side racks from unit. 

6. 

Refit racking in reverse order once cleaning has been completed. 

Stainless Steel Surfaces 

 Clean with detergent.  Baked on deposits or discolouration may require a good quality stainless steel 

cleaner or stainless steel wool.  Always apply cleaner when Salamander is cool and rub in direction of 

grain. 

Vitreous Enamel Surfaces 

 Do not use wire brushes, steel wool or other abrasive material.  Clean enamelled surfaces regularly 

with a good quality domestic oven cleaner.  Remove rack and side racks from Salamander - this 

allows easy cleaning of flat enamelled side walls.  Leave tray in to collect all residue. 

Trough Tray 

 Empty and clean daily.

Always turn ‘Off’ gas supply before cleaning. 

This appliance is not water proof. 

Do not use water jet spray to clean interior or exterior of this appliance. 

Caution