Walimex 16280 Instruction Manual - page 5
5
−
Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity or moisture. A short-
circuit can warm up the conductors, so that there isolation will melt or even melt thoroughly. This
could lead to fire.
−
Please just use the original cables, which are included in delivery. They are aligned for your
device and guarantee the necessary safety for you and your device.
−
Don´t operate the device with wet hand or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages could be caused through
heat impact, chemical influence or through mechanical impacts as rubbing, bending, tearing,
rolling over or nibbling animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before switching on again.
−
If your device should be damaged or defect or if you notice a burning smell:
Disconnect the power supply by pulling out the power cord immediately. Never operate your
device with damaged housing, damaged reflector, defect lamps or damaged power cord. Don´t
open the device. Never repair the device on your own. The device should only be repaired by
electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required specifications.
See Technical Specifications.
WARNING
Fire danger through overheating
The device can overheat, if you operate it with covered ventilation openings.
The accessories can overheat, if it does not comply with the necessary specifications. The device
itself, accessories and easily inflammable materials in close distance could catch fire.
−
Don´t cover the device during operation.
−
Please just use accessories and spare parts, which are conform to the required specifications.
See Technical Specifications.
−
Remove easily inflammable materials, which are in close distance to the device.
−
Remove light materials and objects around the device, which could be moved into the device.
3.
Unpack and check the device
•
Please unpack your device carefully.
•
Please check, if the delivery is complete:
•
1 Wind Machine 500
o
1 Power Cord
•
1 Instruction Manual in German and English
•
Please check, if the delivery is undamaged.
ADVICE: If the delivery should be uncomplete or damaged, please contact info@foto-walser.de or
our service hotline with the telephone number +49 84 32 / 9489-0.