Walimex Pro TTL FW 950 Instruction Manual - page 3
3
I.
Overview of components and operating elements of the device
1.)
Reflector screen
2.)
Built-in wide angle diffusion disk
3.)
Flash head
4.)
Connecting socket sync cable
5.)
Sync cell
6.)
Battery compartment
7.)
Connecting socket for external
power pack (SD-8A)
8.)
Flash mount
9.)
Locking wheel
10.-11.) Contact pin
12.) Display
13.) PILOT – Test button
14.) Mode button
15.) Standby display
16.) Left selection button
17.) On/off switch
18.) Zoom button
19.) Right selection button
20.) Set button
II.
Installation
1.
Inserting the batteries
Opening the battery cover
Slide the battery cover in
direction of the arrow and lift it.
Inserting the batteries
Insert the batteries as indicated
on the battery
compartment/cover. Ensure
correct polarity + / -.
Closing the battery cover
Slide the battery cover back into
its original position in direction of
the arrow.
Attention:
Attention when replacing the batteries. After use, the batteries can be hot.
When not in use, please remove the batteries from the device, in order to keep a possible
leaking of the batteries from damaging the device.