Walimex Pro TTL FW 950 Instruction Manual - page 5
5
5.
S1 mode
Press the MODE button and set the flash device to the S1 mode.
This allows you to use the flash device as a slave flash in order to
work with several flashes simultaneously.
When the flash is set to the S1 mode, it triggers in sync with the master flash.
6.
S2 mode
Press the MODE button and set the flash device to the S2 mode.
This allows you to use the flash device as a slave flash in order to
work with several flashes simultaneously.
When the flash is set to the S2 mode, it triggers in sync with the second flash of the
master flash.
Note: For a summary of your settings, press one of the arrow buttons for longer than 2 seconds.
7.
Energy-saving mode
In order to save energy, the flash device switches to the stand-by mode when not in use.
Press any button to switch it back on.
8.
Protection function
Protection during continuous flashing
In order to prevent the flash head from overheating and being damaged, please do not
flash continuously more than 20 times at the highest output level. The stand-by display
blinks green. Allow the flash to cool off for a few minutes. When overheating, the
overheating protection is activated. Allow the flash to cool off for a few minutes or
reduce the flash output by 1/4.
9.
Status of the stand-by display
Status
Lights up red
Flash is charging
Lights up green
Ready for use
Blinks green
Automatic overheating protection – ready for
use after approx. 2 minutes
Blinks red
Drop of power – replace batteries