WANHAO DUPLICATOR I3 MINI Instruction Manual - 3.1 Unboxing and Assembly

PRODUCT ASSEMbLY& INITIAL SETUP

3.1 Unboxing and Assembly

Your WANHAO 3D Printer is carefully packed to avoid damage in transit. Take your time 

unpacking it. The printer is preassembld and requires only minimal set up before powering on.

1.  

Carefully remove the 3D printer from the box and 

place on a clean, level work space.

2.  

Cut the 2 x Cable ties holding the Print Bed to the 

X-Axis Frame.

3.  

Unscrew and remove the outer plastic nut from the

Filament Spool Holder, then insert the nut into the side 

slot of the towers. Screw in the Filament Spool Holder

into the side of the Printer.

NOTE:  

Ensure the Filament Spool Holder is secure and

do not overtighten

4.  

Ensure the power switch is in the OFF position,then 

the power supply cable into the back of the 3D Printer.

Insert the other end into a nearby mains power outlet. 

Turn on the power outlet, then turn on the power switch

at the back of the 3D Printer.

5.  

After a few seconds, the LCD display screen will 

initialize and show the Home Screen.

15