WANHAO DUPLICATOR I3 MINI Instruction Manual - 5.1.2 Nozzle Cleaning
27
SERVICING
5.1 Servicing your Duplicator I3 Mini
5.1.1 Replacing the print mat
The Duplicator I3 Mini includes 2 x extra prin mats. Additional print mats are available for
purchase from https://www.wanhao3dpriner.com
1. Remove the current print mat by slowly peeling from one corner
2. Using rubbing alcohol and a microfiber towel,carefully remove any residual adhesive
left in the print bed
3. Peel the 3M backing from the new print mat
4. Gently place the new print mat onto the print bed,making sure to align with each edge.
It is recommended to start at a corner to ensure no bubbles become present
5. Use the scraper to apply pressure on the new print mat,ensuring strong adhesion.keep
the scraper level as it can damage the print mat
TIP: You can also use masking tape in lieu of a print mat.Blue painters tape is recommended.
If your Extruder nozzle becomes blocked,follow these steps to clean the nozzle.
1. Remove the existing filament using the steps in Quick settings Chanege filament
Remove filament
2. Using a clean 0.4mm drill bit,insert the drill bit into the nozzle by hand,twisting while
inserting
3. Remove the drill bit from the nozzle, twisting while removing
4. Repeat steps'2' and '3' three times,then follow the steps in Quick settings Chanege
filament Add filament