Wanscam AJ series User Manual - page 11
IPCAM User Manual
11
3.2. Logging and Active X installation
1.
Open the Web page. You can open it directly by first clicking the Inner Access or Outer
Access on Finder and then clicking Open; and you can also directly input the corresponding
address of the inner and outer access into the address bar of the web page, as the address shown in
the picture above
http://192.168.1.126
:81 (LAN); and
http://aodn.ipcam.hk
(WAN)
2.
If the IP camera has been connected with the outer network when you are browsing it,
the log-in interface as below will appear when you open the web page through LAN or
outer work.:
Before IE monitoring through web, it is necessary to install the IP Camera player:
installation mode as below:
Open disk, find
that icon. Double click the icon, process installation.
Click the next step until finished.
There are two way to logging IP camera
1. Open it directly by first clicking the Inner Access or Outer Access on Finder and then
clicking Open; and you can also directly input the corresponding address of the inner and outer
access into the address bar of the web page, as the address shown in the picture above
http://192.168.1.99
:99 (LAN); and
http://demo.88safe.com:99
(WAN)
(Figure 3.2)
Note:
1.
Device information indicates the IP camera information.
2.
When the
current computer has a fixed IP, (namely non-DHCP IP), and the IP
camera is used for the first time, please click Update, so that IP address
of the IP camera, gateway and DNS can be synchronous with the PC.
3.
If it is necessary to manually modify the contents including camera
name, HTTP port, IP address, sub mask, gateway, primary DNS
server, secondary DNS server and so on, please click apply after
modification, and then click OK after entering username and password
of the IP camera in the pop-up dialog box for access validation.