Wanscam AJ series User Manual - page 20
IPCAM User Manual
20
The above setting is a preparation for the alarm function, the sender should be
entered the sender’s email address,recipient 1、2、3、4 is filled with recipient E-mail
address;SMTP server should be filled with the sender email SMTP server,e.g. the
sender email address is abc@163.com,and enter mail.163.com. Generally SMTP port
is 25,do no need to change;when needs to check, just tick it, and enter SMTP user
and SMTP password,both of them are provided by Email provider,and test according
to reference;when needs to send, please tick Email notification Internet IP address;
The e-mail server and other information can be obtained from the mail service
provider the email notification is image captured when alarming if no email
notification is needed when alarming, and then no need to enter.
Set up FTP service, you can fill in parameters like following:
Figure3.14
The above setting is equally similar to Mail Server Settings,when alarming is
triggered it also sends image,please enter FTP server、FTP port、FTP user、FTP
password, FTP upload directory、FTP mode,FTP mode has two options: PORT and
POSV. If needs a quick upload image, then select it, edit upload image interval
(second)
3.4.7 Alarm Service Settings
As shown below, there are two modes of alarm trigger, first one is motion detection,
pleas refer to below interface,the sensitivity of motion detection can be adjusted
according to the users′ requirement, the higher the number is, the lower sensitivity
is; Another mode is input alarm, when connected, it triggers alarm through alarm
input signal which connects to linkage alarm GPIO;
When triggered, there are 3 alarm modes:one is IO alarm linkage, camera connects
with linkage alarm box through GPIO, sound the siren ;the second is email
notification, send email with images captured;the last is upload pictures alarm,as the
way mentioned before FTP upload pictures alarm, Upload pictures interval(second)