Approx. 72” thermal control unit approx. 60” approx. 42” approx. 24” heating element transformer to 120v house outlet free design service • 24/7 installation support • (800) 875-5285 • www.Warmlyyours.Com warmlyyours feelswarm® countertop heater installation instructions.
Thank you for purchasing a warmlyyours feelswarm® countertop heater! Please read the following information to learn how to install and operate your countertop heater. Heater model: custom adhesive-backed heater standard adhesive-backed heater other electrical information (please retain for future re...
Package contents: • adhesive-backed heating element • thermal control unit • transformer (with power cord) • velcro packet • hole plug • peel test strip • thermal control unit mounting tape • instruction manual • surface prep kit • 2 cans of epoxy (part a and part b) • small brush • tongue depressor...
Read these instructions completely before starting assembly and installation. 1. Evaluate and prepare the surface of the countertop a. Evaluate the lower surface of the countertop to determine if the surface prep kit must be used to securely bond the heater. Use the peel test strip included in this ...
Preparation 1. Protective eyeglasses are required. 2. Wear gloves and appropriate clothing. 3. Cover surface of the work area and the carpet or flooring under the countertop to protect these areas from drips or spills of the surface prep coating. 4. On the underside of the counter, use a pencil to m...
Installation instructions section 2 5 2. Perform a test installation of the heater before starting a. After the surface is prepared, conduct a preliminary fit by leaving the white release liner on the heater and holding the heater under the counter to ensure it fits as expected and that there are no...
Installation instructions section 2 6 3. Drill cable hole in cabinet a. Evaluate how the cable from the heater will reach the outlet inside the cabinet. Consider how the wire will feed and where an access hole needs to be located in order to route the heater cable within the framework of the cabinet...
7 4. Attach the heating element a. With the heating element lying on the top of the counter with the white release paper facing up, peel the white release liner off the heater— do not discard. B. Reduce the size of the release liner into manageable pieces by ripping the white release paper into smal...
5. Activate perimeter adhesive once the heating element is attached, the high-bonding adhesive must be fully activated. Important: the heater has a perimeter bonding adhesive that provides the premium adhesion of the edges of the heating element to the stone. Press extra hard within the area within ...
9 7. Install thermal control unit the thermal control unit (tcu) permits the temperature to be adjusted down from the automatic maximum temperature of the heater and provides a quick method for turning the unit on or off. Plug the transformer into the tcu. Then, plug the power cord from the tcu into...
8. Secure wires your warmlyyours feelswarm® countertop heater is supplied with a packet of velcro patches to secure the wires inside the cabinet. Because the length of the wires provided often exceeds what is needed, warmlyyours recommends securing the wires to keep them out of the way of normal act...
