WarmlyYours FeelsWarm Installation Instructions Manual - 8. Secure Wires
8. SECURE WIRES
Your WarmlyYours FeelsWarm® Countertop Heater is supplied with a packet of Velcro patches to secure the wires inside
the cabinet. Because the length of the wires provided often exceeds what is needed, WarmlyYours recommends securing
the wires to keep them out of the way of normal activity. To apply each patch, peel the clear release liner off one half of the
Velcro patch and stick it onto the cabinet wall. Secure the wires using the matching Velcro piece.
9. INSTALL CABLE PLUG
A round cable plug is included with your heater. Using the slit in the side of the plug, place the plug over cable wire, then
insert the plug into the hole in the cabinet. See drawing on page 6.
10. OPTIONAL TIMER
To make operation easier and enhance your experience using your WarmlyYours FeelsWarm® Countertop Heater,
WarmlyYours offers an optional 7-day programmable timer, allowing you to program 14 events or 2 ON-OFF cycles per
day. The timer must be used on a GFCI protected circuit, as it does not have built-in GFCI protection.
10
Plug
2” x 4”
ELECTRICAL BOX
Plug
Hot
Black
Hot
Black
Neutral
White
Neutral
White
Ground
THERMOSTAT
TH115-A-120S
Load
Line
HOT
Yellow
120V
Black
GROUND
NEUTRAL
(WHITE)
LINE (BLACK)
LO
AD (BL
UE)
WHITE
GREEN
BLACK
FROM POWER SOURCE 120V
NEUTRAL
TIMER
Adhesive-
Backed
Heating
Element
Approx. 72”
Thermal Control Unit
Approx. 60”
Approx. 42”
Approx. 24”
Heating Element
Transformer
To 120V House Outlet