Wasco Solar Smart EVMS Installation & User Manual - page 15
INSTALLATION & USER MANUAL
15
Solar Smart Operator
Installation and User Manual
Revision 8.12.2015
16
RE-ZONING
•
Recommended only for when multiple operators are used with a single remote.
•
This process removes the operator from the assigned zone and/or ID number, but remains
paired to the remote. The operator then is reassigned to a new zone and/or ID number on
the same remote.
•
CAUTION - If this is not done correctly, you will have to re-pair the Remote to the
Operator, which would involve unplugging the Operator's battery. Please read these
instructions carefully first, before performing this operation.
1. Press any key to wake up the remote, if the display has powered off.
2. Press and hold MODE , release when PAIR
SET
is displayed.
3. Press MODE again to display RE-ZONE.
4. Press ZONE as necessary to choose the appropriate zone (1 thru 9) of the operator to be
moved to another zone.
5. Press ENTER to save your selection.
6. Press
▲ ▼ to choose the ID number (1 thru 9) within the zone in which the operator is
assigned to.
7. Press ENTER to save your selection.
8. SUCC will be displayed. The operator will now be unassigned from the previous zone and
ID number.
DO NOT STOP HERE, steps 8, 9 and 10 must be completed.
a. Press ENTER to retry, if a FAIL message is displayed instead.
9. Press ZONE to choose the new zone (1 thru 9) the operator shall be assigned to.
10. Press ENTER to save your selection.
11. Press
▲ ▼ to choose the ID number (1 thru 9) within the zone in which the operator shall
be reassigned to.
12. Press ENTER to save your selection.
13. SUCC will be displayed. The Operator will run through an entire open and close cycle.