Wascomat EX-30 S and EX-50 S Operating & Maintenance Manual - Installation
19
Installation
Setting the timing on the electro-
lube oil dispenser
This machine is equipped with an electronic oiler
which lubricate the seals on a timed bases. With
the rear panel removed locate the oiler, which is
attached to the base frame at the lower rear.
Pry off the switch panel cap with a screwdriver.
•
Under the cap are the switches for time set-
ting.
•
The light will start flashing after a few minutes
and will continue to flash every 15th to 20th
seconds as long as the dispencer is in opera-
tion.
•
The decal shown below should be affixed at
the front of the machine and updated as
required.
Fig.
19
2207
19
18
17
2208 A
Date Last Replaced Date Last Replaced
IMPORTANT
NOTICE
This machine is equipped with an automatic oiler,
located at the right rear of the machine, which keeps
it lubricated for long bearing and seal life.
The amount of oil in the container is sufficient for
approximately one year's lubrication. It is of utmost
importance that the oiler does not become empty.
Therefore we recommend that the rear panel be
removed and a visual inspection made on a
bimonthly basis. When the oil reaches a low level,
the cannister must be replaced with a new one
available from Wascomat as Part No. 827601.
Fig.
17
Fig.
18