Wasp WWS800 User Manual - page 4
When you receive your WWS800 Cordless Scanner, it will be in an OFF mode.
This is done to conserve power and for transportation purposes. At the base of the
scanner you will find a small pin hole. Using a straightened paper clip insert the end
of the paper clip into the pin hole and then remove. The scanner will beep and the
LED at the top of the scanner will blink to indicated that the unit is in power ON
mode. The scanner will also power up once inserted into the base.
Please ensure that you power down the scanner if it will not be used for prolonged
periods. This is done by inserting a paper clip into the pin hole at the base of the
scanner. The scanner’s LED will go off and the scanner will power down.
Upon powering up, the scanner will try to establish an RF connection with its base.
At this stage, we need to “pair” the scanner and base.
Turn the base upside down and you will find 2 labels.
The first label has the words “SET CONNECTION” and a barcode. The second
label is the serial number.
To link the scanner to the base, scan the “SET CONNECTION” barcode label. The
scanner will beep once. Next, scan the SERIAL number barcode. The scanner will
beep twice, low then high beep. When it establishes RF connection with the base,
the scanner will emit three short ascending beeps indicating that “pairing” had been
established.
! !"
To charge your scanner, simply place it in the base. The LED on the top of the
scanner will flash RED while it charges. When the battery is fully charged,
approximately 4 hours if the battery is completely discharged, the LED will remain
solid RED.