Watcher E2 Series Manual - page 9
Split Mode: Sets the Main screen display mode (1x1, 2x2, 3x3, 4x4). The boxes below allow you to
change which cameras appear in which window of the main screen.
Dwell Time: Sets the time to change between the cameras on the main screen. This will cause the
cameras to cycle through each camera in each window.
Click the Apply button to save your changes.
If you have a secondary monitor connected to the “spot” port of the DVR, you can change the layout of
that by using the Spot tab. The setup is exactly like Main Monitor options. Other monitors will only
display a copied image of the Main Monitor.
Split Mode: This sets up the display for the secondary monitor. The box below the split mode will set
the Group. You can setup multiple groups to display on the screen.
Dwell Time: Sets the amount of time each camera will display before it changes to the next camera in
the sequence.
Click the Apply button to save your changes.
You can also mask out portions of a camera picture with the Mask tab.
Watcherproducts.com ♦ Watcher Products ♦ 877-289-2824 9