Watchguard SOHO User Manual - page 9
Install the SOHO Remote Management Client
WatchGuard® SOHO Remote Management User Guide
9
C
AUTION
In order to perform the installation process successfully, you must be logged
into the remote management computer with local administrator rights.
Installing the SOHO Remote Management (MUVPN)
Client Software
Follow these steps to install the client:
1
Copy the software installation package to the remote management
computer.
2
Locate and run the installation executable.
If at any time during the installation process you inadvertently skip a step,
simply cancel the process and begin again.
3
The installation package welcomes you to the InstallShield Wizard.
Click the Next button.
N
OTE
During the Setup Status portion of the install procedure, the InstallShield
may detect ReadOnly Files. If this occurs, click the Yes button for each event
in order to continue the install.
4
The installation package again welcomes you to the InstallShield
Wizard. Once more, click the Next button.
The Software Licence Agreement appears.
5
Click the Yes button, to accept the terms of the License Agreement
and to continue with the installation.
The Setup Type window appears.
6
Select the type of setup, by default Typical is enabled–this is the
setup recommended by WatchGuard. Click the Next button.
7
If you are installing the client on a Windows 2000 host, the
InstallShield will detect the native Windows 2000 L2TP
component. The client will use this component and not need to
install its own. Click the OK button to continue with the install.
The Select Components window appears.