Water Right Impression Plus Series Installation Instructions & Owner's Manual - Programming Procedures:
8
Time of day should only need to be set after extended power outages or when daylight saving time begins or ends . If an
extended power outage occurs, the time of day will flash on and off indicating that the time should be reset .
STEP 1 – Press
set
clock
.
STEP 2 – CURRENT TIME (HOUR): Set the hour of the day using + or — buttons . AM/PM toggles after 12 .
Press
next
to go to step 3 .
STEP 3 – CURRENT TIME (MINUTES): Set the minutes using + or — buttons . If it is desired to back up to
the previous step press
regen
button once . Pressing
next
will exit
set
clock
and return to the general
operating display (page 10) .
1. Set time of day:
NOTE: The manufacturer has preset the unit so that the gallons between regenerations will
be automatically calculated after the hardness is entered .
STEP 1 – Press
next
and + simultaneously for 3 seconds .
STEP 2 – HARDNESS:This display will show “–nA– (not available)” if “FILTER”
is selected .
Press
next
to go to step 3 . Press
regen
to exit .
STEP 3 – DAY OVERRIDE:The manufacturer has factory set 3 DAYS as the
default . This is the maximum number of days between regenerations .
If this is set to “OFF”, regeneration initiation is based solely on
gallons used . If any number is set (allowable range from 1 to 28), a
regeneration initiation will be called for on that day even if a sufficient
number of gallons were not used to call for a regeneration .
Set Day Override using + or — buttons (3 is recommended):
• set number of days between regeneration (1 to 28); or
• set to “OFF” .
Press
next
to go to step 4 . Press
regen
if you need to return to the
previous step .
STEP 4 – REGENERATION HOUR:The manufacturer has factory set 12:00 A .M .
as the default . This is the hour of day for regeneration and can be reset
by using + or — buttons . “AM/PM” toggles after 12 . The default time is
12:00 a .m . (recommended for a normal household) .
Press
next
to go to step 5 . Press
regen
if you need to return to the
previous step .
STEP 5 – REGENERATION MINUTES:Set the minutes using + or — buttons .
Press
next
to exit installer programming . Press
regen
if you need
to return to the previous step . To initiate an immediate manual
regeneration, press and hold the
regen
button for three seconds .
The system will begin to regenerate immediately . The control may be
manually stepped through the regeneration cycles by pressing
regen
.
STEP 6 – BACKLIGHT DISPLAY CONTROL (Not available on all models):
Set the display backlight on or off using + or — buttons . In the OFF
position, the backlight will turn off after 5 minutes of inactivity .
2. Programming:
PROGRAMMING PROCEDURES:
1
1
2
2
3
3
4
5
6