The hybrid water purifier user manual congratulations on the purchase of your water purifier f-fweg1-m-a-nt-**-*** warning: boil the water should the purification unit fail.
Declaration 1. If any abnormal case occurs, firstly unplug the appliance. 2. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction conce...
5 important • this appliance is for use with potable drinking water only. Never use this appliance with unknown or unsafe sources • check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance • do not use this appliance if the mains cord, p...
7 1.1 remove the hybrid from the box. To avoid damaging the appliance do not use any sharp object to open the box 1.2 please check the contents of the box and make sure that all items are present 1.3 the uv lamp and filter are pre-installed and ready to use. Hybrid unit reservoir lid dispensing butt...
9 2.6 0 re-fit the reservoir to the appliance making sure it is firmly fitted 2.7 place a glass or large container under the dispense area and touch the dispense button to operate the unit, and touch again to stop the appliance. Allow water to run through the unit until the reservoir has been emptie...
11 3.1 remove the water reservoir from the main body of the appliance. This can be cleaned with a light solution of dishwashing liquid. Never use abrasive chemicals or materials to clean the reservoir as this could scratch and deface the product 3.2 remove the two screws that hold the top cover in p...
13 3.6 insert the new uv lamp while holding the white end caps only. Insert the uv lamp as shown in the illustration and push it all the way down until it cannot go any further caution :- do not use force when removing and inserting the uv lamp as you may damage internal parts :- do not touch the uv...
4. Button functions 3.10 re-fit the top cover, making sure the front is attached first. If the top cover is not fitted correctly the unit will not switch on hint: fit the top cover making sure the front is pushed in place first and then push the back end with the screws down to give a snug fit 3.11 ...
6. Troubleshooting 5. Indication and warning icons 17 5.1 5.2 5.3 your product has been designed and internationally certified to the highest standards of water purification, and guarantees at all times, to dispense the purest and cleanest water. The self monitoring system will warn you of any poten...
9. Safety 10. Certification 11. Disposal • do not touch or look directly into the faucet • do not handle or lift the appliance by holding the reservoir • only authorised trained technicians may carry out repairs on this appliance • the user may only replace the filter and uv lamp • the filter and uv...
