WaterLogic F-FWEG1-M-A-NT Series User Manual - page 6
11
3.1
Remove the water reservoir from the
main body of the appliance. This can
be cleaned with a light solution of
dishwashing liquid. Never use abrasive
chemicals or materials to clean the
reservoir as this could scratch and
deface the product
3.2
Remove the two screws that hold the
top cover in place. You will need to use
a screwdriver to carry out step
3.2
IMPORTANT - UNPLUG THE APPLIANCE
FROM THE MAINS BEFORE REPLACING
THE UV LAMP OR FILTER
SHOULD THE MACHINE FAIL OR
ANY OF THE COMPONENTS FAIL,
AND THE WATER IN YOUR AREA
IS PARTICULARLY HARD, WE
RECOMMEND PURCHASING A
WATERLOGIC DE-SCALING KIT
AND DE-SCALING THE UNIT
THIS PRODUCT IS A HIGH PERFORMANCE WATER PURIFIER, KEEPING IT IN GOOD
WORKING ORDER WILL PROVIDE THE REASSURANCE OF TRULY GREAT DRINKING WATER
PLEASE READ AND NOTE SECTION 6 “INDICATION & WARNING ICONS”
•
The UV Bulb and Filter must be
replaced every 12 months to ensure
that your appliance is dispensing the
highest quality drinking water.
Replacement Parts:
Please make sure you use only original
Waterlogic replacement parts. If you
are not sure which replacement parts
to use, please consult with your local
Waterlogic retailer or distributor
3. UV BULB AND FILTER REPLACEMENT
3.3
Remove the top cover from the unit by
slightly pushing it back and then lifting it up
3.4
Disconnect the UV lamp connector by
holding it and pressing in the clip on the
connector and pulling it up
3.5
To remove the UV lamp firmly pull it up
and out. Do not pull the lamp out at an
angle as it may break or damage the
internal parts of the appliance
Note: The UV lamp must be disposed
of correctly and must not be disposed
of with normal household waste