WaterLogic F-FWEG1-M-A-NT Series User Manual - page 8
4. BUTTON FUNCTIONS
3.10
Re-fit the top cover, making sure the
front is attached first. If the top cover
is not fitted correctly the unit will
not switch on
Hint: Fit the top cover making sure the
front is pushed in place first and then
push the back end with the screws
down to give a snug fit
3.11
Re-fit the two screws that hold
the lid down using a screwdriver.
Caution: The screws should be hand
tightened, do not over tighten
Insert the plug into the mains socket.
3.12
Press and hold the dispense button for
10 seconds until you hear a beep as this
will rest the filter timer
Note: Place a cup or container under
the dispense area before carrying out
step
3.12
3.13
The filter now needs to be flushed,
follow step
2.3
through to
2.8
4.1
When the appliance is in standby mode
the button will be blue but when it is
touched it will turn green and water will
be dispensed
Note: If the button is not touched within
2 minutes of being activated then it will
automatically stop the flow of water and
turn the pump off.
4.2
Touch to STOP dispensing water.
When you touch the button to stop
water being dispensed the button will
change colour from green to blue
Note: After one minute the product is
in a stand-by mode it goes in an energy
saving mode as the UV is off; when the
product is in this condition, there will
be a 2 second delay before the water is
dispensed after the dispense button is
touched so as to activate the UV lamp
and purify the water.
15