Watershot WDS-5D MK II Owner's Manual - page 5
Watershot WDS-5D MK II Housing
Maintenance
Insurance
1. After use and prior to storing the Housing, soak it in lukewarm water
for about 12 hours without the camera installed. While soaking,
periodically manipulate all of the dials and buttons several times, this
will aid in dissolving any salt deposits.
2. After soaking, towel dry, remove the Back Cover, remove and
lubricate the body seal and port O-ring, wipe off body seal and O-ring
contact surfaces with a clean soft cloth.
DO
NOT
use alcohol,
thinner, benzene, solvents or any other cleaning agents on the
Housing, Lens Ports, body seal or O-ring.
3.
DO NOT
use any sharp object or tool to remove the Housing Body
Seal or Port O-ring. Such objects could damage sealing surfaces
and cause leakage.
4. Store the Camera Housing out of direct sunlight in a cool dry place.
5. Use only Watershot supplied O-ring lubricant. Any other O-ring
lubricant may cause O-ring deformation, and or damage which may
lead to water leakage.
6. Replace the Housing Body Seal and port O-ring annually. If the
Housing is stored with the Body Seal and O-ring installed,
DO NOT
use the storage seal and O-ring while diving. The storage seal and
O-ring may become deformed over time and cause leakage.
7. While traveling via airline, remove either the Main Body Seal or the
Housing Lens Port to eliminate pressurizing the housing. If the
Housing is inadvertently pressurized it may become difficult to open.
WARNING
DO NOT use any sharp object/tool to remove seals or O-rings.
Such objects could damage sealing surfaces and cause leakage.
Watershot recommends that you obtain insurance for your Housing,
Camera, Lenses, and other imaging equipment. Protecting your imaging
equipment from the risk of an unforeseen incident is always the best
policy.
Page 12
Watershot WDS-5D MK II Housing
17
18
35
39
9
36
24
28
31
14
2
15
16
11
38
27
26
23
32
20
29
30
33
21
19
34
37
40
22