Watkins CalderaSpas Utopia Series Owner's Manual - page 42
If the pH is too high, it can be decreased by adding sodium bisulfate (pH/Alkalinity Down) to the spa water.
NOTE: After adding sodium hydrogen carbonate or sodium bisulfate, wait two hours before testing the water for pH. Measurements taken too soon may not be
accurate.
It is important to check the pH on a regular (weekly) basis. The pH will be affected by the bather load, the addition of new water, the addition of various chemicals, and
the type of sanitizer used.
When the pH is within the recommended range, proceed to the final step.
4. MaInTaInInG THe sanITIZer leVel
Sanitizer is extremely important for killing algae, bacteria and viruses, and preventing unwanted organisms from growing in the spa. At the same time, you don’t want too
high a sanitizer level, or it can irritate your skin, lungs, and eyes.
Always maintain the sanitizer level in your spa at the recommended level for each type of sanitizer.
Watkins recommends the following sanitizer:
SPA FROG
•
®
sanitizing system (mineral and bromine)
Watkins also approves the following sanitizers:
Sodium Dichloro-s-Triazinetrione (sodium dichlor or chlorine)
•
Biguanide
•
WARNING: DO NOT use tri-chlor chlorine or any type of compressed bromine or chlorine, acid or any type of sanitizer which is not recommended by Watkins
Manufacturing Corporation.
THe waTkIns waTer MaInTenanCe QuICk reFerenCe GuIDe
Ideal range (ppm)
what Chemicals to use
steps
Min.
Max.
To raise
To lower
1 Total alkalinity
40
120
sodium Hydrogen Carbonate or
sodium Bicarbonate
sodium Bisulfate
2 Calcium Hardness
100
150
Calcium Hardness Increaser
use a mixture of 75%
hard water and 25% soft
water or use a stain and
scale Inhibitor
3 pH
7.2
7.8
sodium Hydrogen Carbonate
sodium Bisulfate
4 sanitizer
see section on Maintaining the sanitizer level
sPa FrOG waTer Care sYsTeM
The SPA FROG Water Care system is comprised of the following products:
The SPA FROG mineral cartridge
•
that introduces minerals into the spa water, inhibiting bacteria growth. When combined with Monarch
®
MPS and MPS Plus,
it oxidizes particulates in the spa water.
The SPA FROG Bromine (BCDMH)
•
is the only recommended sanitizer that will work in conjunction with the SPA FROG mineral cartridge in this system.
Monarch MPS Plus Non-Chlorine Shock (MPS/Monopersulfate)
•
is an oxidizing chemical used to prevent the buildup of contaminants, maximize sanitizer
efficiency, and improve water clarity.
Monarch Corona Discharge (CD) Ozone Generator
•
(optional)
- The Monarch high output ozone system is the only ozone purification system approved
for installation in your Caldera
®
Spa. The Monarch ozone system utilizes CD technology to produce a higher concentration of ozone than is produced by
competing chip style CD or ultraviolet light ozone systems.
NOTE: Refer to your SPA FROG Owner’s Manual for start-up and operation instructions. The Owner’s Manual is included with the SPA FROG starter kit.
It is important to follow the recommended application and maintenance programs outlined for each product’s use. If the spa is being used over an extended period or
time, such as a whole afternoon or evening, additional sanitizer will be needed.
A weekly
“shock treatment” is required. The shock treatment quickly destroys any remaining contaminants while revitalizing the bromine in the water.
To weekly “shock treat” your spa, we recommend that you use either Monarch MPS Plus (sodium dichlor may also be used). Sodium dichlor may be a more
appropriate weekly shock for those users that experience heavy bather load conditions.
IMPORTANT NOTE: Monarch MPS Plus is an oxidizer, not a sanitizer.
sPa FrOG CarTrIDGe rePlaCeMenT InsTruCTIOns
The SPA FROG bromine cartridge should be replaced every 2-4 weeks, depending on User Load. The SPA FROG mineral cartridge should be replaced every 4
months. When replacing the mineral cartridge, it is highly recommended that the spa be drained and refilled at the same time. After refilling the spa with water, balance
the Total Alkalinity (TA), Calcium Hardness (CH) and pH to the recommended levels. Shock the spa by adding Monarch MPS or MPS Plus non-chlorine shock.
40
WATER qUALITY AND MAINTENANCE