WATT AGE Tiger shark Operating Instructions Manual - page 6
6
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.net
❑
Remove the battery cover by pulling down on it with
one hand while holding the transmitter with your other hand.
SECTION 4: ASSEMBLING YOUR TIGERSHARK RTF
❑
Install 8 fresh AA Alkaline batteries, being careful to
make sure that the polarity is correct for each battery.
If you use rechargeable AA NiCD cells,
double-check to make sure that they are fully charged
before installing them into the transmitter. Never
attempt to charge or recharge Alkaline cells.
❑
After double-checking that the batteries are installed
correctly, reinstall the battery cover, making sure it's firmly
seated into place.
PRO TIP
Step 1: Installing the Transmitter Batteries
Step 2: Installing the Horizontal Tail Surface
❑
Carefully push the horizontal tail surface onto the back
of the fuselage, making sure that the precut slots in the tail
fit over the corresponding plastic tabs on the fuselage.
❑
While holding the horizontal tail in place, carefully
secure it to the fuselage using two plastic twist-locks.
To properly install the twist-locks, line up
the slot in the twist-lock with the plastic mounting tab
sticking through the top of the tail. Push the twist-lock
down firmly while supporting the tail from the bottom,
then "twist" the twist-lock 90º to lock it into place.
PRO TIP