WATT AGE Tiger shark Operating Instructions Manual - page 8
8
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to service@globalhobby.net
Step 5: Installing the Wing
❑
Carefully pull the two plastic motor covers off the top
of the motors and set them aside for now.
❑
Carefully slide the back of the wing into the molded
wing mount in the fuselage. When positioned properly,
the precut slots in the wing should fit over the molded
vertical parts inside the wing mount. This prevents the
back of the wing from sliding right or left.
The wing should slide over the screw that's
preinstalled in the base of the wing mount.
PRO TIP
❑
With the back of the wing pushed into position, line up
the two precut holes in the front of the wing with the molded
mounting circle behind each motor.
❑
Making sure that the motor wires are out of the way,
carefully push each of the two plastic motor covers back
into position until you hear them snap into place.
After snapping the plastic motor covers
into place, they still may be slightly loose. This is
normal. They will be screwed into place in the next
procedure.
PRO TIP
Before reinstalling the two plastic motor covers in the next procedure, double-check that the motor wires
won't be pinched or otherwise damaged by the installation. Also, be careful not to accidentally break off either of the two
tan-colored capacitors from the back of the motors.
PRO TIP