WATT AGE Tiger shark Operating Instructions Manual - page 7
7
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
Step 3: Installing the Vertical Tail Surface
❑
Carefully push the tabs in the bottom of the vertical
tail surface between the plastic mounting tabs and into the
slots in the horizontal tail surface.
❑
While holding the vertical tail surface down firmly,
carefully thread two screws into the holes in the mounting
tabs to secure the vertical tail surface into place.
Install the screws from the left side of the
vertical tail surface, as shown. The screws will thread
easily through the foam material and into the other side
of the mounting tabs. Do not overtighten the screws.
PRO TIP
Step 4: Installing the Plastic Wing Braces
❑
Working with one end of the wing for now, carefully
remove the two strips of white protective backing from the
double-sided tape on top of the wing.
❑
Carefully push two plastic wing braces into place on
top of the wing, making sure that the mounting tabs on the
bottom of the wing braces are pushed through the precut
slots in the wing.
Make sure to push the wing braces firmly
against the wing. This will ensure that they stick well to
the double-sided tape.
PRO TIP
❑
Turn the wing over and carefully install four plastic
twist-locks onto the two wing braces, using the same
techniques as when you installed the twist-locks on top
of the horizontal tail.
The plastic wing braces set the correct
angle for the tip of the wing. When you look at the front
of the wing, the tip of the wing should be angled up.
PRO TIP
❑
After installing the two plastic wing braces and four plastic twist-locks on one end of the wing, repeat the same
procedures to install the remaining ones on the other end of the wing.