WATT AGE Tiger shark Operating Instructions Manual - page 9
9
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
While holding one plastic motor cover in place, turn
the airplane upside down and install one screw in the
bottom of the motor housing. Tighten the screw completely
to secure the motor cover and wing into place.
❑
Repeat the same procedures to install the screw in
the second plastic motor cover assembly.
Step 6: Installing the Propellers
❑
Carefully install one propeller onto each motor. To
install the propellers correctly, simply push them firmly onto
the motor shaft.
Two extra propellers have been included
should you break one during landing. We suggest keeping
the extras with you while you're flying, just in case.
PRO TIP
Step 7: Installing the Flight Battery
❑
Remove the battery cover by pushing back on the
molded latch and pulling the front of the cover up.
❑
Plug the connector on the flight battery into the
connector that is inside the fuselage. When plugged in
properly you should hear the connectors "click".
As a safety feature, the connectors can
only be plugged in one way.
❑
Slide the flight battery down into the fuselage, between
the two pieces of Styrofoam
®
, then reinstall the battery
cover, making sure to move the latch forward to lock the
cover into place.
PRO TIP
Do not charge the flight battery before installing it. Charging will be done later. Before installing the flight
battery, make sure that the on/off switch on the side of the fuselage (left side, below the wing) is in the "OFF" position.
WARNING