WattAge SPORT-BIPE EP RTF Operating Instructions Manual - page 10
10
❑
Set the bottom wing onto the bottom of the fuselage.
❑
Line up the center of the plastic doubler on the bottom
of the wing with the center of the fuselage, at both the front
and the back of the wing opening.
❑
Secure the wing into place using two rubber bands,
making sure that the rubber bands pass over the four
plastic tabs on the plastic doubler. This will prevent the
rubber bands from crushing the foam wing.
When installing the two rubber bands, cross
them over each other, as shown. This will secure the
wing into place more firmly.
PRO TIP
STEP 6: INSTALLING THE TOP WING
❑
Set the top wing onto the plastic center-strut assembly
on top of the fuselage.
❑
Line up the four holes in the center of the wing with the
four holes in the plastic center-strut assembly, then secure
the wing to the center strut assembly, using four long screws.
❑
Carefully line up the top of the plastic wing strut with the
two screws, then secure the top wing to the wing strut,
making sure to tighten the two screws completely.
❑
Repeat the previous procedures to secure the other half
of the top wing to the second plastic wing strut.
❑
Working with one end of the top wing for now, carefully push one plastic wing brace into place on the top of the wing,
making sure that the mounting tabs on the wing brace are pushed through the pre-drilled holes in the wing.
❑
Carefully push two short screws through the two holes in the plastic plate, so that the tips of the screws stick out through
the bottom of the wing.
Continued On Next Page
☛
☛
☛
☛
☛