WattAge SPORT-BIPE EP RTF Operating Instructions Manual - page 11
11
STEP 7: INSTALLING THE LANDING GEAR ASSEMBLY
❑
Install the landing gear assembly by simply pushing the
landing gear wire firmly into the molded plastic slot in the
bottom of the fuselage.
☞
The slot is located directly behind the battery door.
To make it easier to install the landing gear
wire, squeeze the base of the wire together while you
push it into the slot.
PRO TIP
STEP 8: INSTALLING THE PROPELLER
❑
Thread one hex nut onto the propeller shaft and tighten
it by hand until it will not thread on any further.
❑
Slide the propeller onto the propeller shaft, making sure
that the back of the propeller slides firmly over the hex nut.
☞
The back of the propeller is molded to fit over the
hex nut.
❑
Slide the flat washer up against the propeller and thread
on the second hex nut. Tighten the hex nut, using an
adjustable wrench, to hold the propeller in place.
❑
Install the rubber spinner cone over the front of the
propeller, as shown. So that the rubber spinner cone is
secured into place properly, make sure to push it firmly over
the propeller.
✦
✦
✦
✦
✦
WARNING
✦
✦
✦
✦
✦
Do not operate the motor or fly the
airplane without the rubber spinner cone in place.
Continued On Next Page
☛
☛
☛
☛
☛
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
When installing the landing gear assembly in the next procedure, make sure that the front of the wheel
pant covers are toward the front of the airplane.