Wattbike PRO/TRAINER Quick Start Manual - page 7
L O O K I N G A F T E R Y O U R W P M
The WPM has an internal battery that requires a full charge
before it is used. This is to allow the charging chip to establish
when the battery is full. We recommend that you charge the
bike with the supplied charger for 16 hours, you can still ride
the bike whilst the WPM is still being charged from the mains.
The bike does have an integrated generator, so when cycling
above 60 rpms the batteries charge. After the bikes initial
charge there is no need to plug the WPM into the mains unless
it hasn’t been used for a while or the battery is lower than 30%.
L I N K I N G U P Y O U R H E A R T R A T E B E L T
The WPM is compatible with many HR belts. They can all be
paired up by selecting Link HR Belt on the main screen then
navigate through to the corresponding make of belt in the
Link HR Belt.
• For example, if you have a Suunto HR belt, scroll to Suunto
(ANT) and select and confirm your belt (whilst wearing it),
the pairing is now complete, this will also save the HR belt
in the WPM memory ready for your next ride.
L I N K I N G U P A N A N T + D E V I C E
The WPM is able to talk to other ANT+ ready fitness gadgets
such as Garmin cycle monitors and watches. Once connected
up the WPM will transmit the Speed, Power and Cadence data
to your device.
To do this:
1. Select ANT Channel on the main menu, scroll to and select
SPC + PWR
2. You can search for the Power, Speed and Cadence sensors
now being transmitted by the Performance Monitor on your
ANT+ device. If there are multiple sensors present, you
can find the ANT ID number a the bottom of the WPM main
screen and select the one displayed on your monitor.