Watts Premier PUR-TEK Installation, Operation And Maintenance Manual - Start Up Instructions
Page 12
Thread the 2 white plastic connectors into the final filter and
tighten.
DO NOT OVERTIGHTEN THESE CONNECTORS
Take blue line from faucet and slide brass nut, plastic sleeve and
brass insert onto the tube, insert into open tank tee. Use wrench
to securely tighten nut while pushing tube.
Select best position to cut the blue tubing to attach both ends to
the final filter. If clips are provided, mount your final filter on the
RO module (see picture).
With directional flow arrow pointing towards faucet, insert blue
tubing into the fitting (make sure tube is pushed all the way into
the fitting). Tighten with wrench securely. Repeat step on blue
line from tank into inlet side of filter.
Step 29
Step 30
Step 31
Turn on the incoming cold water. Check the system for leaks and tighten any fitting as
necessary. (Check over the next 24 hours to ensure no leaks are present).
Open the RO faucet and leave it open until water begins to trickle out. (it will come out
slowly and may sputter at first The water may look dark, which is carbon from the final
filter. This is normal and will go away). Once the water begins to trickle out, close the RO
faucet.
The tank will take between 4 to 6 hours to fill completely (depending on the size of the
membrane, local water temperature and pressure). After the tank has filled, open the RO
If system is connected to an ice maker, turn the ice maker off (or do not allow water to
flow to the ice maker) until Step 3 flushing is complete and the tank has been allowed to
completely fill. Connection from the RO to the ice maker system should have an in-line
valve installed before the ice maker so it can easily be closed to prevent water flowing to
the ice maker during start up and periodic maintenance. Your RO tank must be allowed to
fill up in order for the ice maker system to work properly. (If you are installing an ice maker
kit from Watts, tee off after the final filter).
Complete the warranty registration (page 25) and submit to Watts Premier. Premier uses
this information to provide the latest information about water quality concerns as well as
a free filter change reminder service. Inspect the reverse osmosis system periodically to
ensure the unit is functioning properly.
Start up Instructions
Step 3
Step 4
Step 5
Step 2
Step 1
Step 32
Faucet to flush the tank completely to remove carbon particles from final filter. Repeat this
step two more times. The fourth tank can be used for drinking. Note: The flushing of the
tank 3 times is only necessary during initial installation. This should take about a day to
complete.