Wattstopper InteliSwitch AS-100 Installation Instruction - page 7
www.wattstopper.com
TROUBLESHOOTING
1. Verify that all connections are tightly secured.
2. Ensure that all wiring is properly done according to the schematic (see Wiring
section).
3. Check for the correct option setting if the audible beep or Automatic-ON
operating mode does not work properly (see SETUP section).
4. When choosing automatic commands to delay OFF, shut OFF or turn ON the
switch by interrupting power to the switch, check the specifi ed time duration
and make sure the resolution for timing is +/- one-quarter of a second (see
Operation section).
5. Check to make sure that the ground terminal is connected. The AS-100 will not
operate properly without a ground connection.
6. If the AS-100 is still not functioning properly, call 800.879.8585 for technical
support.
WARNING
TURN POWER OFF AT CIRCUIT BREAKER
BEFORE WORKING ON WIRING.