Wavion WBSn-2400 Quick Start Manual - page 6
WBSn-2400 Quick Start Guide
Page 6
Grounding best practices,
using a data protection
device (continued)
Grounding outdoors injector by Network Protection Unit
Connecting Antennas (for WBSn-2400-O only)
Important note: The antennas should only be connected once the installation procedure has been
successfully completed.
How to connect the
antennas:
Screw each of the three antennas into the three N-type connectors on the
WBSn-2400-O base station unit.
Warnings
• In order for the WBSn-2400-O to work properly, all three antennas must
be connected.
• Only connect the unit to the power supply once all the antennas are
connected.
• Use caution when connecting the antennas. Undue haste can damage
the unit.
• Do not screw in the antenna when holding its top section, or you may
damage the antenna.
Antenna Sealing
The following procedure describes how to correctly seal the antennas against moisture.
Caution
• It is important to carefully read this procedure and perform all the steps,
to ensure maximal moisture protection.
• Use high quality sealing material to ensure IP-67 compliant protection
against dust and water.
How to seal the
antennas:
1. After the antenna is connected, use the supplied isolation tape to cover
the N-Type connectors and the lower part of the antennas.
2. Cut 18 cm of the attached splicing tape and ensure that the sticky side
of the tape is exposed.
3. Stretch and wrap the tape in an even, half-lapping manner around the
antenna and N-Type connector. Cover this with a layer of vinyl plastic
tape.