WeatherTech AlloyCover Installation Instructions And Owner's Manual - Preparation
2
NOTE ON BED LINERS: With an under-the-rail drop-in bed liner, installation is possible
with minimal trim/cutting of bed liner at front corner of box and back by tailgate to allow
side rail to install properly. Considerable trim/cutting is required with an over-the-rail
drop-in bed liner.
NOTE: For additional protection against the elements, locate and seal miscellaneous
factory holes, crevices, stake pockets, etc. that may be on box (sealant not included).
NOTE: Rails may be contoured to follow the shape of the box.
Rail clamps
Unpack cover components and clean truck box if dirty.
COMPONENTS:
(1) Driver side rail
(1) Passenger side rail
(8)
Clamps
(1) Pre-folded cover assembly
TOOLS NEEDED:
- 1/2" wrench
- Torque wrench with 1/2" socket
- Spring clamp - optional
- Tape measure or ruler
- Protective eyewear
- Marking pen
Left side rail
Front catch
towards front of box
Right
side rail
Latch on rear
panel
Cover assembly
Front of cover (closest to
cab) has storage
clip retainers