WeatherTech AlloyCover Installation Instructions And Owner's Manual - Troubleshooting
4
5
PROBLEM
Gap between cover
and tailgate
Rails set too high (Refer to Step 1C)
Top of tailgate hits cover when
attempting to close
Rails set too low at rear of cover, raise
rails at rear of box until cover no longer
interferes with tailgate operation (Refer to
Step 1C)
Latch doesn’t engage
Check side rails for height and level. (Refer
to Step 1) Inspect latches for jammed or
broken parts
Cover is not parallel with rails
With cover installed on box, loosen
hardware on both retainment
brackets (DO NOT REMOVE HARDWARE).
Unfold cover to closed position and square
up with box. Carefully fold cover back to
open position and retighten retainment
bracket hardware.
Seal on edge of cover is not sealing
tight against top of box
Rail set too high (Refer to Step 1C)
TROUBLESHOOTING
SOLUTION